<VV> ENGINE ASSEMBLY ORDER

[shortle]

I don't think it matters much Mike. I usually do 1 side (1,3,5) and then the other. Then with 1 side installed I immediately install the lower cylinder baffle before installing the cylinder head.
Timothy Shortle in Durango Colorado 81301


-----Original Message-----
>From: Michael Kovacs via VirtualVairs <virtualvairs at corvair.org>
>Sent: Jul 10, 2014 8:10 PM
>To: VV <virtualvairs at corvair.org>, "fastvair at yahoogroups.com" <fastvair at yahoogroups.com>
>Subject: <VV> ENGINE ASSEMBLY ORDER
>
> I'm ready to assemble the cyl-piston assys into the crankcase. Is there a preferred order ? Like 1,2,3,4,5,6  or 2,4,6,1,2,3. Etc. This just has to do with ease of getting to the bolts to torque them.
>
> I have built several engines in the past 40 years and can't remember if one sequence had better access than an other.
>
>Thanks.
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________