<VV> 64 seat belts

[Frank DuVal]

Middle holes are a thumb to pinky distance on my hand on a slight angle towards the rocker area. Maybe an inch or so from the inner most seat bolt nut( there are two seat nuts on the inboard rear mount). 

Frank DuVal

> On Apr 6, 2019, at 2:34 PM, FrankDuVal via VirtualVairs <virtualvairs at corvair.org> wrote:
> 
> Most states required front seat belts for the 1964 model year (maybe some just after January 1, 1964) so the built in 7/16-20 nuts in the floor should be real noticeable.  I doubt ANY 1964 Corvair was built by Fisher without these nuts in the floor. In fact, I have yet to see any early that did not have them, even a 1960 model.
> 
> The side holes are in the "rocker" area, since there is the extra interior rocker section in an early convertible.
> 
> More details later.
> 
> Frank DuVal
> 
> 
>> On 4/6/2019 1:52 PM, Grant Young via VirtualVairs wrote:
>> Hoping some one can send me a link to, or detailed instructions for, installing front seat belts in a '64 convertible. I know there are supposed to be some pre-drilled holes somewhere, but don't want to pull up extra carpet.
>> Thanks,
>> Grant