<VV> How to advice on replacing rear wheel bearings on LM?

[Joel McGregor]

Yes, the backing plate stays with the hub.
The hub will come out with the inner flange attached.
I made some pliers to remove the e-brake cable with a short piece of pipe split in two with one half welded to each jaw.
Joel

-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of John Gull via VirtualVairs
Sent: Wednesday, June 07, 2017 4:45 AM
To: virtualvairs at corvair.org
Cc: John Gull <vairdude at gmail.com>
Subject: <VV> How to advice on replacing rear wheel bearings on LM?

Well I need some advice on how to remove rear wheel hubs? Looks like rear brake backing plate has to be removed as a unit. what do I plug the brake line with to prevent fluid loss? Does inner u-joint flange have to come off before removing unit from car? Any other advice will be greatly appreciated. Thanks in advance for your help. John Gull in Asheville NC  _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property of the writer, please attribute properly. For help, mailto:vv-help at corvair.org This list sponsored by the Corvair Society of America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________