<VV> Oil pickup install

[Bob Gilbert]

If I remember correctly the tool that makes removing the push rod tubes out 
is the correct size to help install the tube.  AFAIR


----- Original Message ----- 
From: "Matt Nall via VirtualVairs" <virtualvairs at corvair.org>
To: <virtualvairs at corvair.org>
Sent: Saturday, October 11, 2014 2:06 PM
Subject: Re: <VV> Oil pickup install


>
>
>
> I have the Clark's ( Otto ),  oil pickup and I'm trying to install it into
> the crankcase. Is there a trick to doing it so as not to damage either the
> pickup or the crankcase? It's not budging with lubricant and gentle
> persuasion with a rubber mallet.
>
> Karl in Boston
>
> ===============================================================================
>
>
> Freeze it!
>
>
> Matt Nall
> Charleston, Oregon
> http://tinyurl.com/The-Corvair-Patio
>
> http://tinyurl.com/Matts-Tech-Pages
>
>
>
>
>
>
>
> ______________
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
> 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com