<VV> Need help putting 140 block into PG

[J. R. Read]

I'm confused - you want to put a 140 into a PG car or a 4 spd manual car? 
Yep, the bell housings are different.  The exhaust is different between a 
110 and a 140.  The 140s are different between manual and PG trans.  4 
degree crank retard on PG 140.

So, please help us understand your intentions better.

Thanks
Later, JR
----- Original Message ----- 
From: "Charlie" <chaz at properproper.com>
To: "'Rodney Spooner'" <rodneyspooner at corvairgarage.com>
Cc: <virtualvairs at corvair.org>
Sent: Sunday, April 20, 2014 8:11 PM
Subject: <VV> Need help putting 140 block into PG


> Hi Rodney Spooner and VV -
>
> Look time out of touch but I want to get back into a Corvair if possible 
> ...
>
> I need help putting a 140 block that has a manual bell housing, etc, into 
> my
> 67 PG Monza.
>
> Can you tell me if the 110 stuff that I'm removing with the 110 will port
> over or do I need more/different parts?
>
> I bought a 140 block (reported to run) at GWFBT and I was going to convert
> to a Saginaw 4-speed (also bought there) but want to get it running to 
> make
> sure the engine is good enough to go the Saginaw 4-speed route first.
>
> Any ideas?
>
> CC to VV also ...
>
> Charlie
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com