<VV> Fwd: Lifter Question/mea culpa

[HallGrenn at aol.com]

____________________________________
 From: HallGrenn at aol.com
To: corvairduval at cox.net
Sent: 3/4/2013 9:03:28  P.M. Eastern Standard Time
Subj: Re: <VV> Lifter Question/mea  culpa


All:
 
Mind's going.  Frank and Mark caught it.  I tighten 3/4 turn  AFTER I can't 
twist the push rod.
 
Got to stop answering when I'm eating lunch at work.
 
Bob
 
In a message dated 3/4/2013 8:34:33 P.M. Eastern Standard Time,  
corvairduval at cox.net writes:

Bob,

SO you leave it at just the point you cannot turn the  push rod, or go 
another 1/2, 3/4 ?

Frank


On 3/4/2013  11:43 AM, hallgrenn at aol.com wrote:
> Bob,
>
> This will go  on for days, but what has worked for me is the following.  
I add some  moly cam lube to each end of the push rod, install it correctly 
with the  side oil hole at the rocker, dry the push rod just below the 
rocker so I  have some traction for my fingers and then tighten 3/4 turn or until 
I can't  twist the push rod between my dry fingers any more.  I also add 
moly  cam lube to the rocker ball and valve stem face.  Works for  me.
>
>  Bob