<VV> Clutch fork

[Michael Demeter]

He did not sat it was easy!

Mike


On Mon, Dec 9, 2013 at 12:18 AM, <Sethracer at aol.com> wrote:

> That is the easy part, Clark. The real trick is maintaining that
> configuration as you slide the spring clip over the pivot ball and the arm
>  into
> place. Doh! - Seth
>
>
> In a message dated 12/8/2013 5:40:39 P.M. Pacific Standard Time,
> chartzel at comcast.net writes:
>
> Squeeze  the fingers and the fork together so it all fits INSIDE the
> bearing
> flange.  Clutch won't work right if outside the  flange.
> Clark  Hartzel
>
>
> _______________________________________________
> This  message was sent by the VirtualVairs mailing list, all copyrights are
> the  property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of  America,
> http://www.corvair.org/
> Post messages to:  VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>