<VV> Windshield wiper switch access: '65 Monza convert

[Frank DuVal]

Just remember the switch does not feed +12 volts to the wiper motor.

The wiper switch GROUNDS the wiper motor.

Frank DuVal

On 8/16/2013 12:05 PM, Harry Yarnell wrote:
> Loosen the set screw on the knob and remove the knob. Next is a 9/16" (I
> think) nut to remove, and the switch drops out the back. You could remove
> the instrument cluster to gain some better access.
>
>
>
> -----Original Message-----
> From: virtualvairs-bounces at corvair.org
> [mailto:virtualvairs-bounces at corvair.org] On Behalf Of John Westbrook
> Sent: Friday, August 16, 2013 11:54 AM
> To: virtualvairs at corvair.org
> Subject: <VV> Windshield wiper switch access: '65 Monza convert
>
> I'm troubleshooting my inop wipers.  I have voltage to one pin of the 2 spd
> wiper motor but not the other.  Would like to gain access to the switch.
>   Can anyone suggest the best way to get to the sw?  Is it possible to
> partially drop the panel to reach the rear of the sw without removing the
> steering wheel?
>
> Many thanks,
> John Westbrook