<VV> Fw: Exhaust port tube fit to manifold

[Ron]

I use a big rubber hammer and it works fine.
RonH

----- Original Message ----- 
From: "Frank DuVal" <corvairduval at cox.net>
To: <virtualvairs at corvair.org>
Sent: Monday, September 17, 2012 9:43 PM
Subject: Re: <VV> Fw: Exhaust port tube fit to manifold


>I would not worry about a slight loose fit to the manifold. The new
> seals will prevent leaks there. I tap (beat) the manifolds in place with
> a hammer while tightening the nuts.
>
> Frank DuVal
>
>
> On 9/17/2012 9:28 PM, Doug Mackintosh wrote:
>> Andy Kinzelman pointed out that I did not ask the question I meant to ask 
>> in my original post. My Title was correct, but I bungled my question.
>> The issue I am dealing with is a loose fit between the exhaust port tube 
>> and the MANIFOLD,  not the head.
>>
>> Sorry for the confusion, and if you answered the question I asked, please 
>> feel free to answer the question I MEANT to ask now.
>>
>>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>