<VV> Fan belt clearance

[Frank DuVal]

Matt, not if you support the engine first, loosen the castle nut, and 
let the bracket slide to its new position before tightening everything. 
DO not change the transmission shims and everything will fit fine 
without aligning.

Just like dropping the whole drivetrain, which I do on earlies.

Frank DuVal



On 1/12/2012 9:48 PM, Matt Nall wrote:
>
>
>>   Yes..64  or any earlier engine with AC...
>>
>>
>> OR  just trim yours...  It's only a hanging load..very little twist
>> with the IRS
>
>
> A couple of washers on each stud under the bracket will make it work
> without having to whittle anything.
>
>
>
> tony..
>
> =================================================
>
>
>
>
>   But Tony.. that changes TOE!!!     towards "Toe-out"..  not good unless re-aligned!
>
>
> Even on a 60!!! gg
>
>
> Matt Nall
> Charleston, Oregon
> http://tinyurl.com/The-Patio
> http://tinyurl.com/Matts-Tech-Pages
>
>
>
>
>
>
>
>   _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>   _______________________________________________
>