<VV> Plastic tubing for Headers

[Ron]

How about a hot air gun rather than a torch, will it get hot enough?
RonH

----- Original Message ----- 
From: "BBRT" <chsadek at comcast.net>
To: <virtualvairs at corvair.org>; <fastvair at yahoogroups.com>
Sent: Friday, November 04, 2011 3:00 PM
Subject: <VV> Plastic tubing for Headers


> >From Barry.
> ----- Original Message ----- 
> From: Barry Ellison
>
>
> Go to HD for $5 and buy a 10' section of 1.5" gray plastic electrical 
> conduit.  Using a torch heat it up slowly...SLOWLY, more on the outside of 
> the bend for stretching... and you can bend it like butter around 
> anything.  Hold it till it cools maybe 20-30 secs... BOOM!  It's done!
>
>
> Saw it on the DIY channel and put a small bend in some stuff I buried. 
> Don't hold long or it will scorch and/or burn.
>
>
>
> Barry
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>