<VV> Late Model Lower Ball Joint install?

[Frank DuVal]

Ditto

The uppers are riveted in. The rivets. An be cut with an air hammer. 

Frank DuVal

On Dec 26, 2011, at 8:00 PM, "Harry Yarnell" <hyarnell1 at earthlink.net> wrote:

> Pressed.
> 
> -----Original Message-----
> From: virtualvairs-bounces at corvair.org
> [mailto:virtualvairs-bounces at corvair.org] On Behalf Of rich dixon
> Sent: Monday, December 26, 2011 7:42 PM
> To: virtualvairs at corvair.org
> Subject: <VV> Late Model Lower Ball Joint install?
> 
> Hi; On a late model Monza, can the lower ball joints be removed with a
> impact hammer for example, or do they need to be pressed out? And any ideas
> who may stock them outside of Clarks. 
>  
> Thanks
>  
> RD
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
> 
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________