<VV> 1963 turn signal switch cable attachment

[Frank DuVal]

The straight wire just slides into the spring steel finger of the 
switch. This makes it adjustable. Loosen the screw on the moveable 
finger on the switch and the steel wire will move freely.

There was no need to remove the cable from the steering column innards 
(upper cup) to replace the switch.

Frank DuVal

On 12/13/2011 5:13 PM, jeandelucca at aol.com wrote:
> hi, i am awaiting my new turn signal switch, i have removed the old one and cable. i see the screw and clamp set up, but the steel end of my cable is just straight, no hook or anything where it goes into the sliding part. is something missing? i would appreciate any information on the proper installation technique. thanks, jim