<VV> Used Crank Gear

[BobHelt at aol.com]

In a message dated 4/28/2011 6:26:17 P.M. Mountain Standard Time,  
westerncanadacorsa at shaw.ca writes:

Are  there any issues with have a machine shop pull a good used crankgear  
off
one crank, and press it onto  another?



Regards,

Joel



Hi Joel,
Just a couple. First it will take a 30 ton press. Be sure that the machine  
shop has the capability. Then be sure that you have them install a 
replacement  paper gasket between the crank and the gear. it's necessary.
Regards,
Bob Helt