<VV> Re/ Pulled head stud/block repair

[Dennis Pleau]

You would never want to try only one short one.  Two works some times and
sometimes it doesn't.  Be sure to run a 3/8-18 die over the interference fit
threads on the block end of the studs before trying to screw it into a
Helicoil or any other insert.

dp

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Rodney Spooner
Sent: Sunday, April 24, 2011 7:34 PM
To: 'Jim Simpson'; cityhawk at sprint.blackberry.net
Cc: 'Virtual Vairs'
Subject: Re: <VV> Re/ Pulled head stud/block repair

If the Helicoils are short why couldn't you use 2 to make the full length of
the threaded hole? Would that be a KISSolution?

Vairy truly yours,
Rodney Spooner
Riverside, CA 92501