<VV> Another carb adjust question - Choke measurement

Ron ronh at owt.com
Fri Sep 24 16:06:03 EDT 2010


Where?  Item 3 in the write-up for Fig. 13 along with the picture is plenty 
of description.  A 3/16" drill is fine for doing the measurement.
RonH

----- Original Message ----- 
From: "Charles Lee" <Chaz at ProperProper.com>
To: <virtualvairs at corvair.org>
Sent: Friday, September 24, 2010 11:16 AM
Subject: <VV> Another carb adjust question - Choke measurement


> I've updated the carb page for reference :
>
> www.yourbuyersinn.com/Cars/Corvair/1967MonzaCarburetors.htm
>
> My current question is : Where is the .180" to .195" measured in Adjust
> Vacuum Diaphragm Figure 13 (page 6-7) ?
>
> I will get Bob Helt's carburetor book for future use, but I want to work 
> on
> this before I could get the book.
>
> Thanks for you help - I've never done a carb before (other than installing
> carbs bought 'rebuilt' at meets) !
> Charlie
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 



More information about the VirtualVairs mailing list