<VV> gas pedal bracket

[Dave Keillor]

You can also refer to the assembly manual for correct orientation.  

If you're installing a Clark's repro pedal, put a spacer -- either
temporary or permanent -- between the sides of the pedal bracket.  The
splined shaft has to cut new splines in the new pedal and without the
spacer, you'll collapse the splined side of the bracket.

Dave Keillor

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Rick Norris
Sent: Tuesday, September 07, 2010 2:40 PM
To: barnaby at shaw.ca; Dave Ziegler; virtualvairs-bounces at corvair.org;
N2VZD at aol.com
Cc: virtualvairs at corvair.org
Subject: Re: <VV> gas pedal bracket


Remember,
When you pull the pedal off the splined shaft to mark its positon so you
can 
easily reassemble it at the correct angle.

Rick Norris
#36 Sunoco Corvair
www.corvairalley.com