<VV> cancel cam on turn signals
J R Read_HML
hmlinc at sbcglobal.net
Sun Aug 8 01:24:46 EDT 2010
I think you already have "jerry-rigged" it by using a '65 part on a '61 and
it ain't gonna work. Check page 87 of Clark's. You'll see the difference.
Later, JR
----- Original Message -----
From: "Harry B. Stewart" <harry.stewart at usa.net>
To: <virtualvairs at corvair.org>
Sent: Saturday, August 07, 2010 10:25 PM
Subject: <VV> cancel cam on turn signals
>I bought a 61 raampside that was missing the "guts" to the steering wheel,
> etc.
> My 65 Green Brir was the source of the parts and I think I got it all
> going
> but 2 things. The turn-signal "pod" from the 65 won't slide down the
> steering
> shaft far enough to get lock nut for the wheel on far enough. Second
> there is
> a half circle of plastic sicking out from the bottom of the steering wheel
> about 1 1/2". It is labled turn signal cancel in shop manual blow up
> drawing.
> It seems way too big for the task and if I turn wheel more than 15 degrees
> the wheel wants to stop turning. I'd likr to just tak it off, but then I
> would
> lose horn and turn signal cancel...unless I jerry-rig it.
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list