<VV> PG shift cable

[Clark Hartzel]

Good point!  You would have to mount the plate a couple of inches higher
than the connection to the transmission to be above the oil level.
Clark

-----Original Message-----
From: Dave Ziegler [mailto:dziegler3 at comcast.net] 
Sent: Thursday, August 05, 2010 9:28 AM
To: Clark Hartzel
Cc: Virtual Vairs
Subject: Re: <VV> PG shift cable

I would think it would leak from the cut ends into the box?

Dave.. .
On Aug 4, 2010, at 8:13 PM, Clark Hartzel wrote:

> As I recall there is only a foot difference in cable lengths  
> between a car
> and a Rampside.  Tim's Crampside is shorter by the width of the  
> ramp (3')
> I liked the idea of making a box or just a plate you can clamp the  
> cut ends
> of the outer cable to and then overlap the steel inner cable and  
> use a cable
> clamp or two.
> You need to save the dash end and the PG end and cut the middle  
> somewhere.
> Clark Hartzel
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all  
> copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv- 
> help at corvair.org
> This list sponsored by the Corvair Society of America, http:// 
> www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/ 
> virtualvairs
>  _______________________________________________