<VV> SHORTENED PG CABLE

[Dave Ziegler]

I believe there is a procedure for this in the Tech Guide.

Dave.. .
On Aug 3, 2010, at 8:17 PM, Thomas Gwyther wrote:

>
> i dont know if it would work, you might try to use one from a car.
>
> you may not need to shorten it
>
>
> thomas gwyther
>
>> From: N2VZD at aol.com
>> Date: Mon, 2 Aug 2010 06:41:22 -0400
>> To: virtualvairs at corvair.org
>> Subject: Re: <VV> SHORTENED  PG CABLE
>>
>> has anyone ever done a good neat job of shortening a PG cable?
>> i need to start thinking about fixing the horrible mess under the
>> "crampside" soon. i will make all new harness , tubing , and shift  
>> cable   soon.
>> my latest shortcut bit me , i had a set of nice very low miles 65  
>> 110hp
>> heads that looked like new. i put new seals on the intakes ,  
>> cleaned them up ,
>>  and used copper 052 gaskets. at the time the gasket surfaces  
>> looked good ,
>> after  cleaning things up. anyhow i ran the motor on my hydraulic  
>> table .
>> it runs  great. BUT it decided to blow a head gasket right away. i  
>> now have
>> it apart  again , sending heads out for rework soon.
>> that's my saga for today...forgot to mention that the alternator  
>> pulley is
>> a great meat grinder ...makes short work of the end of the thumb.   
>> so far ,
>>  i feel jinxed this summer. long story.
>> regards, tim colson
>>
>>  _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all  
>> copyrights are the property
>> of the writer, please attribute properly. For help, mailto:vv- 
>> help at corvair.org
>> This list sponsored by the Corvair Society of America, http:// 
>> www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: http://www.vv.corvair.org/mailman/options/ 
>> virtualvairs
>>  _______________________________________________
>  		 	   		
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all  
> copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv- 
> help at corvair.org
> This list sponsored by the Corvair Society of America, http:// 
> www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/ 
> virtualvairs
>  _______________________________________________