<VV> Electronic Ignition Question/answer

[Sethracer at aol.com]

In a message dated 10/10/2009 2:53:47 P.M. Pacific Daylight Time,  
shortle556 at earthlink.net writes:

If a  Pertronix is installed in a naturally aspirated Corvair, does one 
need to  change the coil? How about the amount of voltage to the coil? As I 
recall  Corvairs used a resistor wire which cuts down the voltage. 
Timothy Shortle  in Durango Colorado
Getting ready to take the Rampside PG to Palm  Springs




Tim - I was really trying to avoid that question. As a matter of facts, I  
think I still will. Pertronix has a web site that is full of advice.
 
_http://www.pertronix.com/prod/ig/flame/coils/40000_volt.aspx_ 
(http://www.pertronix.com/prod/ig/flame/coils/40000_volt.aspx) 
 
Seth  Emerson

C's the Day! - Corvair, Camaro,  Corvette