<VV> new heads, VirtualVairs Digest, Vol 54, Issue 53

[jvhroberts at aol.com]

?A FAM may be all that's needed, but a SAM has more possibilities. 

For machining castings like this, the speed and accuracy are amazing, not to mention the flexibility. This is pretty much what all machining is going to, called flexible tooling. No jigs, just programming!

The speed is the key to low cost. 


 


 

-----Original Message-----
From: ScottyGrover at aol.com
To: virtualvairs at corvair.org
Sent: Tue, Jul 21, 2009 11:49 am
Subject: Re: <VV> new heads, VirtualVairs Digest, Vol 54, Issue 53










 
In a message dated 7/21/09 3:23:07 A.M. Pacific Daylight Time, JVHRoberts  
writes:

Sounds like you've never seen a six axis  machining center in action 
before! In a three up head, what's funny shaped?  It's a nice big rectangular 
part! All you need is a couple of registration  points to make it mount up the 
right way. 



No, but I've seen videos of a 5-axis mill carving an engine block out of a  
solid slab of metal------amazing!!
 
Scotty from Hellyweird (it's finally summer  here!!)
**************What's for dinner tonight?  Find quick and easy dinner ideas 
for any occasion. 
(http://food.aol.com/dinner-tonight?ncid=emlcntusfood00000009)
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the 
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________