<VV> LM Accelerator Pedal

[Frank DuVal]

I've had good luck using a wire wheel on a bench grinder to clean these 
two parts up. That is once you beat them apart! ggg

Paint the mounting part, use new bushings and grease the shaft part. It 
needs to move freely. There may have been some mill coating on the steel 
before it was stamped, but most of our eastern ones are rust colored.

Frank DuVal

Chris Mann wrote:

>I found a good diagram of the accelerator pedal assembly in the Underground book. It took me a good hour to get the 7/16" nut off, it was so rusted
>it didn't even have form to fit the wrench or socket over it.
>Were these steel assembly pieces all raw steel when the car was new? I was thinking it would be good to shoot a coat of primer and black paint on all these parts b4
>reinstalling them all again. Good idea? Or just keep it dry in the future?
>
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>  
>