<VV> Outer strut rod bolt

Rick Norris ricknorris at suddenlink.net
Wed Nov 21 20:59:03 EST 2007


I have had to cut a few out but I usually get it out with the impact gun and 
being stubborn helps too!
Rick

>I don't recall ever breaking one off but up here in Michigan everything
> rusts into place.
> I've had pretty good luck just letting my impact wrench "hammer away" on 
> it.
> While the air compressor is running and building pressure back up, keep
> squirting PB Blaster or other rust dissolver on it.  Let the impact wrench
> hammer away on it again and it will eventually come loose.  I don't know 
> if
> it helps the next guy but I always coat my bolts with grease before
> installing a new one.
> Clark Hartzel
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.503 / Virus Database: 269.16.2/1142 - Release Date: 
> 11/20/2007 5:44 PM
>
> 



More information about the VirtualVairs mailing list