<VV> Flushing Brakes for Silicone Fluid

[Harry Yarnell]

I too would be afraid of putting alcohol in a good MC. I'd think compressed 
air should be sufficient. I doubt the remaining glycol film would be a 
problem.

harry yarnell
perryman garage and orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "Blaine Sanders" <utvairs at yahoo.com>
To: <virtualvairs at corvair.org>
Sent: Thursday, November 15, 2007 10:17 AM
Subject: <VV> Flushing Brakes for Silicone Fluid


> Somebody please refresh me mammaries here...
>
> What's the procedure for flushing the brake system in preparation for 
> switching over to silicone fluid?  If my 'member correctly, you use 
> rubbing alcohol?  But what if your master cyl is completely dead and won't 
> pump alcohol through the system?  Should I use my new MC?  I'm afraid 
> alcohol would dry up the new cups/seals.  What say ye?
>
> Thanks as always,
>
> Blaine
>
>
>
> 
> ____________________________________________________________________________________
> Never miss a thing.  Make Yahoo your home page.
> http://www.yahoo.com/r/hs
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>