<VV> no reverse pg

[Harry Yarnell]

I did the video for Clarks, so I think it's pretty good :)
No reverse is usually due to a bad (hard/leaky) reverse piston seal.
You might try one of the 'tunups-in-a-can'; the one I like is made by 
Seafoam. Try it; it may swell the seal to do its job.
They used two different reverse piston seals in the Powerglide thruout 
production; one a lip seal, the other a square cut job. The lip seal is a 
better seal.

harry yarnell
perryman garage and orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "shortle" <shortle556 at earthlink.net>
To: <virtualvairs at corvair.org>
Sent: Wednesday, February 14, 2007 3:17 PM
Subject: <VV> no reverse pg


> Tech help needed:My 63 Rampside PG has been working beautifully when all 
> of a sudden I have no reverse. Fluid is full and VERY clean (I am 
> religious about clean fluids in all my cars). Any thoughts/suggestions? If 
> it is rebuild time, is Clarks video a good source for info? Any other 
> references out there for tech support? I have all the factory manuals but 
> am hoping for more. Thoughts, please. Thanks, Tim.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>