<VV> Cross Duct and Inlet Duct/Blower Assembly

[J R Read_HML]

When you figure out how to make that happen, write a tech article 'cause I'm 
sure there are plenty of folks who want to know that answer.

Later, JR

----- Original Message ----- 
From: "Jim" <shamrox75 at yahoo.com>
To: <virtualvairs at corvair.org>
Sent: Saturday, September 02, 2006 8:17 PM
Subject: <VV> Cross Duct and Inlet Duct/Blower Assembly


>I would like to refurbish these items on my 64 two-door.  I haven't been 
>able to remove these items.  Is it possible to remove without dropping the 
>rear end?
>
>  Thanks,
>
>  Jim Condon
>
>
> ---------------------------------
> Do you Yahoo!?
> Everyone is raving about the  all-new Yahoo! Mail.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.11.7/436 - Release Date: 9/1/2006
>
>