<VV> Cross Duct and Inlet Duct/Blower Assembly

[Ron]

The shop manual says to remove the drivetrain as the first step for getting 
at the heater box and I assume that that's it unless you have an FC.  You 
didn't say what you were working on.
RonH

----- Original Message ----- 
From: "Jim" <shamrox75 at yahoo.com>
To: <virtualvairs at corvair.org>
Sent: Saturday, September 02, 2006 6:17 PM
Subject: <VV> Cross Duct and Inlet Duct/Blower Assembly


>I would like to refurbish these items on my 64 two-door.  I haven't been 
>able to remove these items.  Is it possible to remove without dropping the 
>rear end?
>
>  Thanks,
>
>  Jim Condon
>
>
> ---------------------------------
> Do you Yahoo!?
> Everyone is raving about the  all-new Yahoo! Mail.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>