<VV> Gas tank sending unit seal

[Frank DuVal]

Good thought Doug. That little nylon nut does get loose when fiddling 
with the sender.

Also, if the "nut" on the sender is installed with a hammer and chisel, 
the ends of the "nut" that are hammered on will bend and make full 
engagement impossible. But he is  using a real tool, so that shouldn't 
be it.

Frank DuVal

Doug Mackintosh wrote:

>At the risk of insulting your intelligence - are you SURE it's the gasket leaking? The little gasket sealing the electrical connector pin can leak (sometimes it is just loose) and when that happens it will dribble down under the clamp ring, then out the bottom, making a very good impression of an o-ring leak at the bottom.
>   
>  Just checking to be sure.
>
>
>-- Doug Mackintosh
>  Corsa member since 1996
>  Corsa/NC member since 1996,  Virtual Vairs member
>  Corvair owner 1969-1971 and 1996-on
> 		
>---------------------------------
>Yahoo! Messenger  NEW - crystal clear PC to PC calling worldwide with voicemail 
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>  
>