<VV> My 110 HP Lawn Mower!

[Secular]

  Hi Dan:

  The valves were adjusted while the car was running (about a year ago). 
  In fact, if anything, I believe I set them at an additional 1/4 turn after 
  the knocking stopped. (loose). 

  I'll check the wire from distributor going to coil. The coil itself
  is fine...I placed it in my 65 to see if I could duplicate the issue. 
  It ran with no problems. 

  Tony

----- Original Message ----- 
From: <vairdan at localnet.com>
To: <virtualvairs at corvair.org>
Sent: Friday, August 04, 2006 11:22 PM
Subject: Re: <VV> My 110 HP Lawn Mower!




  Valves too tight?

  Distributor wire breaking down where it goes into the distributor?

  Coil breaking down or wrong? I put a brand new chrome coil on mine
and had the same thing happen, it was either bad or was wrong voltage
or wan't grounded correctly inside. I threw the old one back on and it
peped right back up.

  Just a few ideas to check out.

  Anyone want to buy a shiney chrome coil used just 30 miles! still
in the brand new box on the shelf in my garage. Looks real good!
Cheap!

  VairDan


 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________