<VV> PG engine into 4 speed car (clutch pilot bushing install)

[BobHelt at aol.com]

In a message dated 4/19/2006 7:42:04 PM US Mountain Standard Time,  
monza63mo at peoplepc.com writes:

I  noticed that the bushing will be an extremely tight fit and I want to 
avoid  any possible damage to the new bushing or the crank.  Any advice?   Special 
tool needed?

Art



Hi Art,
The best way to install the pilot bushing after lubing it with motor oil,  is 
to place it on the end of the transmission input shaft and tap on the other  
end of this shaft with a small hammer.
Regards,
Bob Helt