<VV> Westach CHT gauge

[Jim Houston]

How about drilling a hole large enough for the wires to pass through to 
include a grommet.  Then seal the hole around the wires in the grommet 
with (gasp) silicone.  Should work.

Jim Houston
Brandon, FL



Padgett wrote:

> Just received the dual CHT gauge and sensors from Westach and have a 
> question: the thermocouple goes around the tip of the spark plug. How 
> do you get the sensor wire out of the shroud ? Am tempted to notch the 
> hole in the shroud where the plug boot mounts with a nibbler unless 
> this is a no-no. Any opinions ?
>
> Padgett
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>