<VV> LM Jacking

[BBRT]

Correction
----- Original Message ----- 
From: "BBRT" <chsadek at adelphia.net>
To: <virtualvairs at corvair.org>; "Padgett" <pp2 at 6007.us>
Sent: Friday, September 16, 2005 7:59 PM
Subject: Re: <VV> LM Jacking


> There are triangular jacking pads just forward of the rear wheels and 
> frame members just aft of the FRONT wheels. Alternatively, a two by three 
> or four between the pinch weld and outer portion of the rocker panel can 
> be used. CG is about 4" aft of the rear of the door (coupe).
> Chuck S
> YS 73
> ----- Original Message ----- 
> From: "Padgett" <pp2 at 6007.us>
> To: <virtualvairs at corvair.org>
> Sent: Friday, September 16, 2005 7:50 PM
> Subject: <VV> LM Jacking
>
>
>> Hokey folks, given all of the rong ways mentioned, what is the correct 
>> way to jack up the rear end of a LM to replace the starter & remove the 
>> lower shrouds ?
>>
>> Padgett
>>
>> _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights 
>> are the property
>> of the writer, please attribute properly. For help, 
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America, 
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs 
>> _______________________________________________
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________