<VV> LM Jacking
BBRT
chsadek at adelphia.net
Fri Sep 16 19:59:06 EDT 2005
There are triangular jacking pads just forward of the rear wheels and frame
members just aft of the wheels. Alternatively, a two by three or four
between the pinch weld and outer portion of the rocker panel can be used. CG
is about 4" aft of the rear of the door (coupe).
Chuck S
YS 73
----- Original Message -----
From: "Padgett" <pp2 at 6007.us>
To: <virtualvairs at corvair.org>
Sent: Friday, September 16, 2005 7:50 PM
Subject: <VV> LM Jacking
> Hokey folks, given all of the rong ways mentioned, what is the correct way
> to jack up the rear end of a LM to replace the starter & remove the lower
> shrouds ?
>
> Padgett
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list