<VV> lower shroud question

[J R Read_HML]

Originally, there was a metal tab bent over the end of the pin.  Many are 
missing now and there would just be a triangular whole where that tab once 
was.  Use a short sheet metal screw (drill a small hole) with the end of it 
overlapping the end of the pin.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Arthur Landis" <MONZA63MO at peoplepc.com>
To: <virtualvairs at corvair.org>
Sent: Friday, October 14, 2005 6:17 PM
Subject: <VV> lower shroud question


Does everyone replace their lower shrouds in the cooler weather?  Mine were 
both missing the pivot pins and bushings on the exhaust duct dampers so I 
bought new ones.  What I can't figure out is how the pivot pins stay in 
place.  There's nothing to keep them secure.  Can someone please explain to 
me how to properly put the lower shrouds back on and keep the dampers in 
place?

Thanks in advance

Art in Missouri
'66 Sport Sedan
140/PG
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________