<VV> Re: rocker arm ratios

[J R Read_HML]

OK,

So just WHO is DJTCZ?

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: <djtcz at comcast.net>
To: <virtualvairs at corvair.org>
Sent: Sunday, October 09, 2005 8:14 PM
Subject: <VV> Re: rocker arm ratios


>
> snipped and bottom posted
> -------------- Original message -------------- 
>
> From: "David C. Herrin III" <source at adnc.com>
> Subject: <VV> Rocker Arms - Advertisement
> The tooling for the unique Corvair rocker arms @ 1.57 ratio no longer 
> exists anywhere.
>
> --=============================================
> My April 1962 Chevy Service news covering the Corvair Spyder says the 
> rocker arm ratio is 1.5
> Of course there are many ways to make rockers with a1.5 ratio (the rocker 
> could be 9 inches long, for instance) and none of them really guarantee 
> the rocker tip will bear centrally on the valve stem on every engine.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________