<VV> more ????

[Tom Wright]

Hello everyone.

I have the differential together for the 66 Corsa. I am putting the axle yokes in, and I am looking for the torque spec in the manual. I believe the manual calls the bolt an axle yoke nut and wants 100 ft lbs torque on them. Sounds like a lot to me, but if I am reading this right, I will do that to them.

Should the clutch rod that goes from the throwout fork to the pivot arm be strait? May be a dumb question, but mine has two bends in it and I don't know if it is for clearance or some goofy concoction by the PO.

I lubed the pivot ball, and the throwout bearing had lube on it that coated the snout, so I figured this was meant to be. Or will it get dirty and interfere with the throwout movement?

Slowly getting there.

Tom Wright
St.Catharines
www.vaxxine.com/tomspage
VA3TOM
66 Corsa 140
Corsa Ontario
CORSA