<VV> Door Handle Spring

[Bob & Kathy Gilbert]

Hi,
I'm not certain but I don't think they go behind the door panel as that is
where the foam ring fits.
Bob
 

-----Original Message-----
From: J R Read_HML [mailto:hmlinc at sbcglobal.net] 
Sent: March 31, 2005 9:07 PM
To: Bob & Kathy Gilbert; corvairs at cybrus.net
Cc: 'VV'
Subject: Re: <VV> Door Handle Spring

I can't quite recall if they go between the door panel and the plastic (I
think that is the spot - with wide end at the plastic piece) OR behind the
door panel when it is installed ( which would be wide end against the door
panel).  One of those two places.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message -----
From: "Bob & Kathy Gilbert" <bgilbert at redshift.bc.ca>
To: <corvairs at cybrus.net>
Cc: "'VV'" <virtualvairs at corvair.org>
Sent: Thursday, March 31, 2005 9:51 PM
Subject: <VV> Door Handle Spring


> Hi,
>
> I just completed both doors on my 66 vert and in the process of tidying up
> afterwards I came across a set of door handle springs I had ordered ages
> ago. I've never seen these installed on any car I've owned. What function 
> do
> they serve and where exactly do they fit as there's barely enough room for
> the plastic washer under the door handle and the window crank!
>
> Thanks,
> Bob
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are

> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________