<VV> Her car is out of the garage

[Bill Elliott]

Frank's suggestion is right on.. and has been my technique as well. But I think autobody places also carry (or used to anyway) little devices with blades made 
specifically for this...might be a little easier/more forgiving....

Bill Elliott

On Tue, 11 May 2004 14:15:18 -0400, Frank DuVal wrote:

>Anybody have tips for sanding out runs.   I was going to make small
>sanding blocks (about 1 inch wide).


>>
>I use a single edge razor blade. It takes some practice to hold it exactly parallel to the surface, and concave surfaces can be problematic. You might sand the 
two corners of the razor blade so they are not sharp.