<VV> Windshield trim question

[Joe Robbins]

Thanks for the replies on this. I now have the parts ordered and the glass
comes out today if the glass folks show as scheduled. They are giving me
time to be able to clean and rust proof the channel and touch up the dash in
the front .
Joe Robbins
CORSA
PCCA


-----Original Message-----
From: virtualvairs-admin@corvair.org [mailto:virtualvairs-admin@corvair.org]
On Behalf Of airvair
Sent: Monday, May 03, 2004 8:33 PM
To: Joe Robbins
Cc: Virtualvairs
Subject: Re: <VV> Windshield trim question

There are "nails" that are put into the windshield channel at various
places 360 degrees around. They hold the trim clips in, which held the
trim on. The need to be put in before the windshield glass is set.
Location is up to you, as the factory seemed to put them in in whatever
position they wanted.

-Mark

Joe Robbins wrote:
> 
>  Hello all,
> 
> I have a question about the windshield trim on a Late Vert. The two thin
> pieces on each side to be exact. What holds them in other than where they
> lock in at the ends ? Is there a clip that goes on the trim and then
clicks
> into the little stud that is on the inner frame of the car ? Is there more
> than one etc? I think I am missing something and I almost lost one
> yesterday.  Any help will be appreciated as always.
> 
> 
> 
> Thanks
> 
> Joe Robbins
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs@corvair.org
List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
_______________________________________________