<VV> Floor pans
Mark J. Murphy
Mark J. Murphy" <m.j.murphy@comcast.net
Mon, 22 Mar 2004 07:48:19 -0500
I assume this is to be more of a "driver" than anything else. How small are
the holes in the floors, and how many are we talking about? The replacement
panels are nice, but if you only have a few small spots why not grind them
down to good steel and use fiberglass? I have had decent results with small
holes in floors by going over them from the bottom with duct tape then using
fiberglass resin/cloth patches from the inside. Lay in a couple layers and
let it harden then remove the duct tape and undercoat. The tape supports
the fiberglass when wet and the undercoating blends it in nicely.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
,-----___\----, Mark Murphy
\--(o)----(o)--' Derry, NH, USA
http://m.j.murphy.home.comcast.net/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
----- Original Message -----
From: "Keith Wells" <kewells@medscape.com>
To: <virtualvairs@corvair.org>
Sent: Sunday, March 21, 2004 11:32 PM
Subject: <VV> Floor pans
I need new floors. Any
> experience with the pre-formed panels from Clarks? I have never
> welded in floor pans before and dont know how to go about cutting
> out the old floors, esp at the attachment to the frame rails at the
> front and rear.
{SNIP}
Just has small
> holes in the floor and that one worrisome spot in the dog leg at the
> rear