<VV> How high to remove drivetrain?

[mark@noakes.com]

a better number to request is how high is the pad surface on the jack stand since I have
two different pairs  of jack stands, each pair a different brand, and they are not at
the same height per notches.

Mark Noakes

On Fri, 25 Jun 2004 08:14:37 -0400, "Jim Houston" wrote:

> 
> >snip
> > how high does the rear of a late model have to be to remove the complete
> > drivetrain?  I would like to how high in inches as well as to where  do
> you
> > measure on the car?
> 
> >snip
> 
> >  If you take the 6 ton jack stands and put them on  the first notch, then
> > place them at the jack pad area the rear of the car will  be high enough
> to
> > remove an engine or a whole drivetrain. I just did this  yesterday.
> > If you remember that, then there are no numbers to  remember or forget!
> > Ken Hand
> > _______________________________________________
> 
> Ken - I only have 2 ton jack stands.  Could you tell me how many inches tall
> the first notch is on your 6 ton jack stands?
> 
> Thanks in advance,
> 
> Jim Houston
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________