<VV> 140-PG MPG?

[J R Read_HML]

One of the little spring looking (resistors?) on the sending unit is broken
(or at least not functioning).  If memory serves, there are 3 of them
(possibly 4?).  The other 2 (or 3?) are still working.

My rampside has the same problem.  I ignore it because it is accurate at the
E end of the scale... where I need the accuracy.

Attachments are scanned with anti-virus software.

Later, JR
'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
'66 beater Coupe - icemobile 4/140

----- Original Message ----- 
From: <AeroNed@aol.com>
To: <virtualvairs@corvair.org>
Sent: Thursday, April 22, 2004 10:39 PM
Subject: Re: <VV> 140-PG MPG?


> I also have a bum sender (or sealer webbing). My gauge will read no higher
> than 3/4, even when there is gas to the very top of the filler. It goes
pretty
> quick to 1/4 then takes more time to get to E. One time I pushed it by
driving
> a while on E until I couldn't take it anymore and put in 10 gallons. Most
of
> the time I only get 9. My data, (I'm an engineer and have lots of data on
all
> kinds of stuff :^) ) shows a fairly consistent 18 to 20 MPG but I'm
driving for
> fun not economy.
>
> Ned
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs