[FC] Engine rear housing

[Ken Hand]

 ??? I generally put a thin film of sealant on the lower outer half of the housing only. I do make sure to go around the lower stud holes.


 


Ken Hand
Handy Car Care Consulting Services
248-613-8586
www.corvairmechanic.com 

 


 

-----Original Message-----
From: Garry Parsley <geparsley at sbcglobal.net>
To: corvanatics at corvair.org
Sent: Mon, 8 Oct 2007 5:39 pm
Subject: [FC] Engine rear housing










Hey guys,
  When installing the rear engine housing to the block, are you supposed to use 
the gasket dry, or with sealer? The service manual doesn't say, and I can't 
remember. Seems like a lot of oil there not to use some sealer, but then again, 
those passages are awfully narrow and I wouldn't want some wayward sealant to 
block something. And I'd really like to only do this once.
   
  Thanks,
  Garry Parsley
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/



 


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - http://mail.aol.com