<VV> There is always that one Corvair

Seth Emerson sethracer at aol.com
Sat Feb 15 17:50:22 EST 2025








Nice info on the small aluminum plugs source for the H-series!




I always wondered where to get them.




https://quadrajetparts.com/plugs-expansion-cups-c-228_900.html

    On Saturday, February 15, 2025 at 01:00:28 PM PST, tony underwood via VirtualVairs <virtualvairs at corvair.org> wrote:   

 
On 2/15/2025 12:38 PM, CARLETON BRIGGS via VirtualVairs wrote:
> Our St. Louis solution is to remove the 3 aluminum plugs in the carb base
> near the idle needle adjuster. Then run the carbs through a sonic
> (ultrasound) cleaner for 10 -16  minutes to clean out the corn oil that has
> hardened in the up and down
> Idle circuit. Sonic cleaners and supplies can be found at Harbor Freight.


Been there done this already, love my ultrasonic cleaner, works quite 
well, had it long enough to know how to exploit it.  Works for other 
stuff besides 'Vair carbs.  A Carter competition series 735 cfm AFB fits 
the tub with room to spare.   Some dish detergent and a bit of vinegar 
added to the soup helps.


tony..




-- 
This email has been checked for viruses by AVG antivirus software.
www.avg.com
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________
  


More information about the VirtualVairs mailing list