<VV> Hot Starting :

[Fred]

Try a 12v jumper wire to coil, If this cures it,the resistor wire in the harness is bad. This has bitten me before.

Fred Marsh


-----Original Message-----
From: Rick Sanford via VirtualVairs <virtualvairs at corvair.org>
To: virtualvairs at corvair.org
Cc: Bill Sanford <wags12202 at aol.com>
Sent: Mon, Jan 17, 2022 11:58 am
Subject: <VV> Hot Starting :


110 HP 4 speed, New Fuel Pump, New Gas Tank, New Sender / Pick up, New Inline Clear Fuel Filters (not my choice) Rebuilt carburetors (filters removed), New Electronic (FAST) Ignition, New Cap, New Rotor, New 8MM wires, New Spark Plugs, New Oil and Filter. Note: Chokes are disconnected (not my idea either) All connections have double checked for leaks. 



**Problem: Starts easily when Cold “HARD TO START WHEN HOT AND RUNS ROUGH WHEN AT FULL TEMPERATURE”, Fuel Filters (Clear) lose fuel when hot. Once it starts it run rough, and hard to keep running.  Once the car cools off, it starts right up and runs fine, until it gets to full operation Temperature, then it runs rough again. 



Any ideas on what is causing this problem????  



Rick Sanford

843-231-2257



 _______________________________________________

This message was sent by the VirtualVairs mailing list, all copyrights are the property

of the writer, please attribute properly. For help, mailto:vv-help at corvair.org

This list sponsored by the Corvair Society of America, http://www.corvair.org/

Post messages to: VirtualVairs at corvair.org

Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs

Archives: http://www.vv.corvair.org/archive.htm

 _______________________________________________