<VV> Carburetor jets.

[N2VZD TIM]

I use a good screwdriver that fits the slot. You must put the carb on a good solid steel surface when smacking the jet and hold the carb flat. Worst case Drill it Have compressed air ready to clean.
Regards , Tim Colson
Sent from AOL DesktopIn a message dated 1/13/2022 3:18:09 PM Eastern Standard Time, virtualvairs at corvair.org writes: 


Matt Nall
Sea Mountain
SW  Oregon Coast
Drill with LEFT HAND BIT!

Sent from Mail for Windows 666

From: Jerry Brown via VirtualVairs
Sent: Thursday, January 13, 2022 10:41 AM
To: virtualvairs at corvair.org
Subject: <VV> Carburetor jets.

What is the easiest way, if there is,  to get the jets out of a Corvair carb that someone has messed up trying to get them out.   
Jerry

Sent from Yahoo Mail on Android
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________


-- 
This email has been checked for viruses by AVG.
https://www.avg.com

_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________