<VV> weber carb

[R]

Start off by checking the entire intake system for vacuum leaks.
  I take a can of carb or brake clean and lightly spay around any joints/sealing surfaces and see if the RPMs increase.
Then you have found the leak.


RCS



> On Jun 5, 2021, at 3:44 PM, TOM PADAVAN via VirtualVairs <virtualvairs at corvair.org> wrote:
> 
> Hello to All,just rebuilt my 180 turbo, installed pertronixII,sent carb to Wolf for a rebuild car starts fine will not idle any lower than 2/2500rpm no matter what I do,so installed a weber 40dcoe same thing with idle except manifold from turbo to carb gets ice cold lots of condensation both on manifold and inside carb on air tubes, jets etc. WTF,any ideas?
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________