<VV> Loose axle

[Jim Becker]

Why not?  Because the weight of the car is sitting on it.

No, you didn't just do it.  When you tried to do it, and found "The play is 
ALL GONE!!".  It could SEEM TO BE all gone because the car is sitting on it. 
This is just like saying your motor mounts must be good because you tried to 
wiggle the engine by hand and it didn't move, or maybe your house foundation 
is good because you stepped on a threshold and the house didn't sink.

You may not have a problem, but you have no evidence either way.

Jim Becker

-----Original Message----- 
From: Hugo Miller
Sent: Wednesday, March 04, 2020 8:16 PM
To: Jim Becker
Cc: virtualvairs at corvair.org
Subject: Re:  Loose axle

Wny not? I just did it! Unless I had hold of the wrong shaft, as the
actress said to the Bishop ;)

On 2020-03-04 20:49, Jim Becker wrote:
> Are you sure?  With the weight of the car on it, you won't be able to
> just reach up and wiggle it by hand.
>
> -----Original Message----- From: Hugo Miller via VirtualVairs
> Sent: Wednesday, March 04, 2020 6:08 PM
> To: wfcc at mediacombb.net
> Cc: virtualvairs at corvair.org
> Subject: Re:  Loose axle
>
> I should have got underneath before I replied to your post. Guess what?
> The play is ALL GONE!! Can you believe it! Who'd a thunk it? So after
> all that debate, the whole thing was just a massive red herring.
> Thank you so much for spotting the booby trap for the unwary, and
> possibly saving me a whole lot of work in the process!! Well done sir!
> Have a cigar on me ;)
>
> On 2020-03-04 17:56, wfcc at mediacombb.net wrote:
>> Hugo,
>>
>>  I don't think I've  seen it asked here, but this play you are
>> talking about, Is it when the car is jacked up and the wheels are
>> hanging free ? If so that is normal. especially on the side with the
>> short stub axle. They fixed that problem on the much improved late
>> models...…… but Smitty wouldn't know about that…<GGG>
>>
>>
>>  Ed Lindsay
>>
>>  West Florida Corvairs
>> ----- Original Message -----
>> From: Hugo Miller via VirtualVairs <virtualvairs at corvair.org>
>> To: virtualvairs at corvair.org
>> Sent: Wed, 04 Mar 2020 17:45:47 -0500 (EST)
>> Subject: Re: <VV> Loose axle
>>
>>
>> On 2020-03-04 16:02, Smitty wrote:
>> [edited]
>>> I would like you to be more restrained when commenting.  I didn’t see
>>> Bills comments as being patronizing.  Just a knowlegible longtime
>>> Early owner trying to keep a newbie from making what could be an
>>> expensive and time consuming mistake.  It doesn’t pay to assume when
>>> dealing with persons ranging from automotive engineers to a teen age
>>> kid that doesn’t know a left handed monkey wrench from a screwdriver.
>>>        Smitty
>>>
>>> Sent from my iPad
>>
>>
>> This is the comment I described as patronising;
>>
>> "Hugo - please stop tinkering with your car.  Take some time to get the
>> appropriate manuals and read and familiarize yourself with the parts of
>> your car before you go any further.  Or, if not that, meet up with a
>> local Corvair club to look over it with you.
>> Bill"
>>
>> And it is. Damned patronising. Telling me to stop 'tinkering' with my
>> own car. Who has the right to tell me that? I've been 'tinkering' with
>> cars and commercial vehicles in a professional capacity for the last
>> fifty-odd years.
>> I was seeking advice on whether anybody had similar experience of play
>> in the axle shaft, as I couldn't see exactly where it originated. I will
>> happily listen to advice from any quarter. But please don't talk down to
>> me. That is guaranteed to piss me off.
>> Going back to my original question, there seems to be a consensus that
>> the play is where the yoke runs in the diff gear / housing. There is
>> just a remote possibility that a new yoke will cure or alleviate it, but
>> Sod's law says that's unlikely. I've got to drop the whole lot out some
>> time soon anyway, so it will have to do until that happens.
>>
>>
>>  _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all
>> copyrights are the property
>> of the writer, please attribute properly. For help,
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America,
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>> Archives: http://www.vv.corvair.org/archive.htm
>>  _______________________________________________
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________