<VV> Coils.

[FrankDuVal]

Our Delco system works just fine.

Now, should we talk of Lucas Electrics?

Or even that Switch and Circuit Breaker nomenclature? Only circuit 
breaker in Corvairs was in the headlamp switch, until the convertible 
top came along....

HA!

Frank DuVal

On 2/17/2020 12:59 AM, Hugo Miller via VirtualVairs wrote:
> Well that's just crazy. See my earlier post about British coils which 
> were stamped as either 9v (for use with a resistor) or 12v (for use 
> without a resistor). Stamped in the casing, that is, not with a label 
> stuck on. Why would any manufacturer muddy the waters by labelling 
> both 9v and 12v coils as 12v? No wonder people get confused. What 
> happens when the advisory label falls off? That's the sort of thing 
> they would do in Florida!
> Mind you, having said that, British coils in the 50's were marked 'SW' 
> and 'CB' instead of + and -. There were pos earth coils and SW was neg 
> and CB was pos. So when you converted the car to neg earth, you had to 
> wire the switch side of the coil to the distributor and the contact 
> breaker side to the ign switch. Got all that? ;)
>
>
> On 2020-02-17 00:26, Smitty wrote:
>> Hugo I will not contest you on the voltage handling capabilities of
>> the coils.  That would be missing the point.  The point I made was
>> proceeded with , the coils were both new, both were marked 12 volt,
>> and both had the advisement that they were intended to be used with
>> external resistors.
>> As a side note I have worked on cars that had ballast bar resistors
>> with the ,,run,, voltage as low as 6volts and others with ,,run,,
>> voltage as high as 10 volts.  If factory stock components are used
>> then I check the manual.  If they accept the demonstrated voltage as
>> being in the range of normal then so will I.
>>
>> Sent from my iPad
>